ATX ITX power supply diagnostic tester
New LCD monitor atx chassis power supply diagnostic tester PC Power Tester
Method of operation
a. the power 24PIN and P4, P6 or P8 plug into an electrical tester appropriate location.
b. Turn on the power, and the “bit” sound twice startup sound, if the value of each group were not flashing, it means the input power supply is normal.
c. If a circuit voltage signal is not detected (eg 20PIN 20PIN connector socket insert) or the detected voltage is outside the normal range, the buzzer will emit a long time, “drops” warning sound, and the corresponding voltage value or PG status is displayed blinking, it means the power supply is faulty power!
Brief Description: ATX Power Supply Tester
Support 20Pin, 24Pin ATX Power Supply
Support SATA Power
Support P4, 4Pin, 8Pin Interface
Support PCI-E graphics 6Pin power connector
Support molex / Xeco Power Interface
Support floppy power connector
4Pin power connector supports standard SATA interface
Test voltage +3.3 V,-12V, +5 VSB, +12 V1, +12 V2, +5 V
Features: PG automatic alarm, LCD display volts each case
Any supply voltage or PG issues will alarm and display the voltage value, solve the first generation of a set of low voltage tester test is not out of the question! Very convenient, is the power sales personnel and businessmen rare detection tool!
• POWER TESTER 2 2nd Generation Power Supply Tester ATX POWER (LED Screen Blu-ray)
• ATX POWER Power Supply Tester * POWER let you know whether the supply is normal! ! !
Desktops | Servers POWER TESTER 2 2nd generation Power Tester ATX BTX ITX Power full support
• * POWER POWER tester as long as the plug!
The POWER connector into this group of power tester POWER you can know right away if there are problems! ! !
Second generation LCD display the output voltage directly at
Can measure the power voltage of each group 3.3V / 5V / 12V/-12V/SB 5V/PG
If there is bad buzzer alarm.
You can also measure the output wire P4/P6/P8/SATA/IDE
|Dimensions||10 × 8 × 8 cm|